Directions for using SeaKlear™
1. Clean or backwash your filter if applying initial dose
2. Pour the desired amount (100ml treats 50,000 litres of pool water or 2,500 litres of Spa water) into a watering can. Dilute with approximately 5 litres of pool water and mix well. Then walk around the pool pouring the contents into the pool. If your pool water is especially dirty you can double or triple the dose.
3. Allow at least 12 hours of continuous filtration in pools and 30 minutes in Spas. (You can use the pool while it works.)
4. Maintain your water's sparkling clarity by using
SeaKlear™ every week.
That will cost less than 2.50 € a week !!!
An average 8m x 4m pool will contain approximately 45,000 to 50,000 litres of water. A pool that has been allowed to turn green may need more than one treatment and may require a check of the sand filter especially if the sand is 4 or more years old.
The active ingredient in SeaKlear™ is a NATURAL polymer from crab shells. SeaKlear™ will not harm plants, animals or fish. It is safe for your family and our environment. SeaKlear™ is the only water clarifier that forms a & 'cocoon' on your filter to capture the very smallest of particulates (Sun tan oils, lotions and grease) It will NOT clog your filter It washes away each time you backwash your pool. 1 litre of SeaKlear™ will clean an average 8m x 4m pool 8 to 10 times. It also protects your sand filter and cuts down the number of times you need to backwash your pool.
KEEP YOUR POOL WATER CLEAR AND SPARKLING!!
